JF Antique Radio Repair -- Tube Equipment Repair (Radios, Amplifiers, and Car Radios)
www.jfradiorepair.com

     
Cabinet Damaged in Shipping                                            Speaker Damaged in Shipping (Cone Repaired)


SHIPPING/PACKING REQUIREMENTS



  Box Size and Double Boxing:

        Box size should be at least 2 times each dimension (length, width, height) of Equipment to be shipped.

        For Equipment over 10 lbs, double box the Equipment.

        NOTE: Equipment must sustain a 6 foot drop.

  Speaker:

        Place a sturdy piece of cardboard over the Speaker Cone, cut to outer frame, and tape well to frame. Do not use scotch tape.

        Tape wire to Speaker frame.

        Wrap Speaker with medium bubble wrap at least 3 times around. Fold up ends and tape.

  Equipment Preparation:

        SET Radio Dial to low end (550kHz).

        Leave Tubes in Chassis.

        Wad up paper and pack into crevices of Chassis, especially around Tubes.

        Wrap Chassis with medium bubble wrap at least 3 times around. Fold up ends and tape.

  Box Preparation:

        Place peanuts in bottom of box so that when Equipment (Equipment and/or Speaker) is place in, Equipment will sit in the center of box.

        Fill the rest of box with peanuts a little bit higher than top of box. Then seal top.


Home Page